A Simple Math-Free Method for Marking and Cutting Radius Trim
Marking and cutting radius trim can be tricky, and mistakes can be costly. Here, an expert trim carpenter shares their super simple method.
Step One: Draw Parallel Lines
“I’ve never been good at math so when it is time to install eyebrow/radius casing trim, instead of reaching for a calculator, I just make a full-scale layout table. Drawing on a piece of MDF works best for me. Here is how I do it.” – Gary Striegler, trim carpenter.
First, make a full-scale layout table out of MDG.
- Draw a set of parallel lines representing the inside and outside edges of the side casing trim.
- Space them the same width of my jamb opening plus an additional 1/2-in. to account for the two 1/4-in. reveals.
Step Three: Place Curved Trim Onto Layout
- Place the curved trim molding on my layout with the inside edge hitting both marks that were just made.
- Then, draw a line where the inside and outside edges of the trim molding intersect the straight lines that represent the side casing.
Step Four: Draw a Line With a Straightedge
- After moving the radius trim out of the way, use a straight edge to draw a line through the intersecting points. That becomes the cut line.
Step Six: Transfer the Cut Line To the Side Casing
- This layout also allows the cut lines to be transfered to the side casing as well.
- Pro tip: Alternatively, you could transfer those angles with a sliding bevel gauge.
Step Seven: Check the Miters
- Always check the miters by laying the pieces back on the layout table.
- Run the side casing long until you’ve fine-tuned the miters and then cut the bottom ends to achieve the final length.
About the Expert
Gary began working with his father as a trim carpenter in 1972 at the age of 14. As the president of Craftsman Builders, Gary is still a hands-on builder. About half of his time is still spent on the jobsite creating the high-end interiors that have become his trademark.
He is a frequent contributor to Fine Home Building Magazine and The Journal of Light Construction. Gary also enjoys teaching on subjects relating to home building. He has made presentations for The Woodworking Show, JLC Live Shows, Woodmaster Tools, Kreg Tools, DEWALT Tools, Grex Tools, and White River.