15 Revolutionary Techniques for Driving Screws

Using plugs is an easy way to hide screw heads. Simply drive a countersink bit deep enough to create a recess called a counterbore. Then just drive your screws, add a little glue, and gently tap the plugs in. Once the glue dries, you can sand the plugs flush. To make the plugs even less noticeable, align the grain of the plug with the grain of the workpiece. You can make your own plugs or buy packs of them at home centers and woodworking supply stores.

Sometimes the place where you need to drive a screw can be hard to reach without a bit extender. This accessory chucks right into your drill and comes in a bunch of different lengths. Most have quick-release jaws that accept hex-shank drill and driver bits. Buy more than one and you can click them together for even longer reach. Flexible bit extenders are also available.

If you've ever used impact drivers, you know they pack quite a wallop. And sooner or later, all of that torque will snap the ends off your driver bits. Be sure to buy hardened bits made specifically for impact drivers, but be forewarned?they still break, so keep plenty of extras on hand.

Ratcheting screwdrivers make driving and removing screws by hand a breeze, and many come with an assortment of bits that store inside the handle for just about any type of screw head. Keep it in your kitchen junk drawer and you'll always know where it is.

Special bit holders allow one drill/driver to do the work of two. With one type, you just snap a driver bit onto the countersink bit. Another has a countersink bit on one end and a driver bit on the other. You just drill, flip and drive.

When you're installing cabinets on walls, use 'washer head' screws. Their large heads are far less likely to pull through, which is especially helpful if you're working with crumbly materials like particleboard. The self-drilling tips can eliminate the need for pilot holes. And depending on the brand, you can get them with either star-drive or square-drive heads, so they're less likely to fall off your bit or strip out. The screw shown is made by FastCap.

The specially designed tip and threads on many modern construction screws can eliminate the need for pilot holes. Just before this writing, we drove a dozen screws of this type through doubled-up 3/4-in. red oak boards with no pre-drilling. They all drove easily with no stripping or breakage and sat perfectly flush without the need for a countersink bit. We also observed no splitting when driving them near the ends of the boards. Impressive! SPAX and GRK are two brands available.

A right-angle adapter is a handy gadget for driving screws in places where the body of your drill won't fit.

You can drill a pilot hole with a standard drill bit, then create a recess for the screw head with a countersink cutter. Or, you can do both at once with a countersink bit. Pick one up at a home center or woodworking supply store.

We've used drywall screws for all sorts of carpentry projects, with mixed results. They're strong, which is great. But they're brittle, which is not. With so many different types of wood screws available, you're better off using drywall screws only for hanging drywall.