Close Gaps Around Electrical Outlets and SwitchesUpdated: Jun. 30, 2017
Small air leaks can add up to huge energy losses
You might also like: TBD
Fill gaps with foam
Electrical outlets and switches on exterior walls can leak a lot of cold outside air into the house. Add up all the outlets in the average house and you can have some serious heat loss—which makes it worth spending 10 minutes per outlet plugging the holes.
Before you start, flip the circuit breaker off and use a noncontact voltage tester to ensure there’s no power. Remove the cover plate. If the gap between the electrical box and the drywall is less than 1/4 in., fill it with acrylic latex caulk. If the gap is bigger and lopsided, use foam sealant that’s formulated for use around doors and window framing. The minimally expanding foam won’t drip down your walls. After the foam dries, cut away any that protrudes, add a foam gasket (to reduce drafts through the box) and replace the cover plate. Do the same around register openings on the inside of exterior walls.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- 4-in-1 screwdriver
- Non-contact voltage tester
- Utility knife
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- Foam outlet gaskets
- Minimal expanding foam