The only way to fix a recurring drywall crack around a door or window is to bridge the crack with a fresh sheet of drywall. The fix takes a few days, but it will finally make the problem go away.
By the DIY experts of The Family Handyman Magazine
You might also like: TBD
Cut out and replace the drywall
Photo 1: Saw and slice the drywall around the crack
Remove the door trim and cut the drywall horizontally (with a drywall saw or utility knife) to the nearest stud. Then use a utility knife to slice down the center of the vertical stud and also down the center above the door.
Photo 2: Cut and screw on the patch
Cut the patch with the tapered side facing the ceiling and screw it into place with 1-1/4-in. screws.
Photo 3: Bevel the edges
Bevel all the cut edges. That will give the joint compound more "bite" and remove any jagged paper edges.
Photo 4: Mud, tape, sand, mud
Apply joint compound and tape to the vertical seams and embed the tape. Then tape the bottom horizontal seam and finish at the wall-to-ceiling seam. Follow up with sanding and two additional coats.
If you have a door or window with a crack on either side traveling up to the ceiling, there’s probably a drywall butt joint behind it. Installers aren’t supposed to seam drywall at the end of doors, but sometimes they do. Houses settle, and wood expands and contracts, and that area is very susceptible to cracks. A taped joint just isn’t strong enough to handle the stress. Patch the crack and it’ll nearly always show up again. The only real fix is to cut out the drywall and put in a solid sheet spanning the crack-prone zone. The materials are inexpensive, and the job takes about eight hours (spread over a few days). Sure, you’ll have to repaint, but you have to do that anyway, every time you repatch.
Start by cutting out the cracked drywall (Photo 1). Then cut all the way through the taped joint at the ceiling. Remove the old pieces of drywall and any exposed screws and nails. Cut a single sheet of drywall to match the new opening. Screw the new sheet into place (Photo 2). Then clean up all the cut edges (Photo 2). Tape and mud the new seams using paper tape and lightweight joint compound (Photo 4). To avoid repainting and patching against the ceiling, “flat tape” that seam by embedding tape in the mud against the surface (Photo 4).
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.