Save on Pinterest

Fix a Stuck Washing Machine Hose

Solution for removing rusted hoses ends

FH10NOV_STUCLH_01-2 how to unhook a washerFamily Handyman
Replace corroded laundry hoses without ruining the valve by slitting them with a Dremel tool so the hose end will release.

You might also like: TBD

Remove a stuck laundry hose

Photo 1: Slice a corroded end with a Dremel

Cut through the hose end a little at a time until the slice extends through the metal. Don’t forget your safety glasses. Make two slices on opposite sides of the hose end.

Photo 2: Pry it off

If you still can’t unscrew it, pry it loose with water pump pliers. After you’ve removed the hose, clean off any remaining rust and corrosion from the valve threads with a wire brush.

Rusted-on laundry hoses are nearly impossible to unscrew. If you need to remove or replace your laundry hose and just cant get it loose, heres how to unhook a washer solution. Carefully cut through the hose end. Try to avoid cutting too deep, but dont worry if you nick the threads on the valve. The threads dont seal the connection. Thats taken care of by the rubber washer. You can use a hacksaw to make the cuts, but a Dremel tool with an abrasive cutoff wheel works even better (Photo 1). Cut the hose end in two places, then try to unscrew the fitting with water pump pliers or a pipe wrench. If its still stuck, break it off with the pliers (Photo 2).

Required Tools for this Project

Have the necessary tools for this DIY project lined up before you startyoull save time and frustration.

  • Pipe wrench
  • Pliers
You’ll need a Dremel tool and abrasive wheel.