Save on Pinterest

How to Adjust Sliding Shower Doors

Get sticking shower doors back on track

How to Adjust Sliding Shower DoorsFamily Handyman
A dragging shower or bathtub door can permanently damage both the door and the track if ignored for too long. Learn the steps needed to fix it and get it running smoothly again.

You might also like: TBD

Time
An hour or less
Complexity
Beginner
Cost
Less than $20

Adjust a dragging shower door

Photo 1: Remove the guide

Unscrew the guide at the lower edge of the sliding door. Protect the shower or tub from scratches with a drop cloth.

Photo 2: Remove the doors

Lift the door out of its track inside the upper rail. Tilt each door in or out to remove it. Wipe both tracks clean.

Photo 3: Adjust the rollers

Raise or lower each door by repositioning the roller in its slanted slot. Loosen the screw to move the roller.

Close up of rollers

Make sure all your rollers are either round or flat. Don’t mix the two types.

If the sliding doors on your shower or bathtub don’t glide smoothly, repair them soon. A door that drags on the lower track will eventually do permanent damage to both the door and the track. A dragging roller at the top of the door will wear and require replacement.

First, make sure the rollers on both doors are riding on the tracks inside the upper rail. Sometimes, one roller falls out of the track and the bottom edge of the door skids along the lower rail. In that case, you only have to lift the door and guide the roller back onto the track.

If an off-track roller isnt the problem, you’ll have to remove the doors to adjust and possibly replace the rollers. Many doors have a small plastic guide at the middle of the lower rail. To remove this type of guide, just remove a single screw. Others have a guide rail screwed to the door (Photo 1).

With the guide removed, lift the doors out of their tracks (Photo 2). Then make sure the rollers turn easily. If not, apply a little silicone spray lubricant. Some lubricants can harm plastic, so check the label. If the lubricant doesnt do the trick, replace the rollers. Most home centers and some hardware stores carry replacements. Take an old roller with you to find a match. In many cases, you can use a replacement thats slightly larger or smaller than the original. But be sure the original and replacement edges matcheither rounded or flat (see photo of roller types). If you cant find rollers locally, type “shower door parts” into any online search engine to find a supplier.

Screw the new rollers into place and rehang the doors is how to install sliding shower doors. You’ll probably have to remove the doors once or twice to adjust the rollers for smooth operation (Photo 3).

Required Tools for thisHow to Adjust Sliding Shower Doors Project

Have the necessary tools for this DIY project lined up before you startyou’ll save time and frustration.

  • 4-in-1 screwdriver

Required Materials for this How to Adjust Sliding Shower Doors Project

Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.

  • Replacement rollers
  • Silicone spray lubricant

Popular How-To Videos