Spilled a drink on your cordless phone? Don't panic yet—these instructions will show you how to clean your phone and restore it to working condition without paying a bundle.
By the DIY experts of The Family Handyman Magazine
You might also like: TBD
Disassemble, clean and dry the phone
Photo 1: Scrub off the crud
Dip the toothbrush into the cleaning solution and gently scrub the soda residue from the push buttons and the circuit board.
Photo 2: Dry off the parts
Shoot compressed air into the earphone jacks, mechanical switches and all over the circuit board to remove excess water.
Nobody knows who spilled the soda on the portable phone. But now the buttons are all gummed up and you can’t use it. You may have to pitch the phone and buy a new one. But first, here’s how to clean a phone and maybe save it from the recycling center.
Remove the batteries and any screws inside the battery compartment. Check for other screws holding the case together and remove them, too. Then use a butter knife to pry open the case.
Remove the entire circuit board and the silicone push buttons. Cover the speaker, microphone, earpiece and any mechanical switches with duct tape to keep them dry. Then clean all the parts with water/dishwashing detergent solution and a soft toothbrush (Photo 1).
Once you get the crud off, rinse the parts with lukewarm tap water. Blow off the excess water with compressed air (Photo 2). Remove the tape and store the circuit board and push buttons in a bag of rice for a few days. Then reassemble and try making a call. If cleaning the phone has worked, you just saved yourself some bucks. If not, you’re just out a little time.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
You’ll also need a soft toothbrush, a compressed air nozzle and a butter knife.
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.