If the hinge screws have broken out of a particleboard door and taken chunks of the particleboard with them, the right glue can usually fix the damage.
By the DIY experts of The Family Handyman Magazine
You might also like: TBD
Replacing door hinges in two simple steps
Repair a broken-out door hinge
Photo 1: Prep the damaged area
Chisel out the damaged wood and enlarge the area slightly to give the adhesive more area to grip. Remove all loose chips and blow off any remaining dust.
Photo 2: Fill the void with glue
Squeeze in enough glue to fill the broken-out screw holes and coat the cup area. Then press the cup into the opening until the glue oozes out. Drop the screws into the hinge holes and tighten the ones that still have some wood to bite into.
It doesn’t take much of a blow to break hinge screws out of a particleboard door. If the screws just stripped and pulled out cleanly, you could fill the hole with toothpicks and wood glue, then reinstall the screws. But if the surrounding particleboard has broken away, it’s quicker to fill the void with gap-filling glue (Loctite Go2 Glue is one choice, and is available through our affiliation with Amazon.com).
Start by removing the hinge from the door and preparing the damaged area (Photo 1). Apply petroleum jelly to the movable portions of the hinge to protect them from the glue. Then scuff the cup portion of the hinge with sandpaper where it will contact the adhesive. If you’re using polyurethane adhesive, dampen the hinge with water to activate the glue. Apply glue to the damaged area and immediately install the hinge and screws (Photo 2). Secure the hinge with weights or clamps until the glue dries. Then reinstall the door.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you startyoull save time and frustration.
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.