How to Install Stair Spindles
It looks complicated to replace banister spindles...it's not.
There are really just three steps involved in replacing a broken spindle: remove the old one, find a replacement, and fit it in. These tips will help the process go smoothly.
You might also like: TBD
Replacement procedure forbanister spindles
Photo 1: Yank out the broken spindle
Wiggle while you pull and make sure you don’t break off the end of the banister spindle in the hole. You may need a big pair of pliers to do the job.
Photo 2: Deepen the upper hole
Extra depth lets you insert the top of the spindle far enough to get the bottom end of the spindle into the lower hole.
Photo 3: Test the fit
Don’t go for the glue until you’re sure the new spindle fits. Insert the upper end, then drop the spindle into place.
Its true: The banister spindles on your old stair rail werent installed with the notion that they would someday need to be replaced, but dont be intimidatedthey can be, even if the spindles are trapped in holes at the top and bottom.
First, you need to remove the damaged spindle. If the spindle isnt completely broken in half, finish the job with a saw. Then persuade both pieces out of their respective holes.
Next, find the proper size spade or Forstner bit, and overdrill the top hole. Be careful not to punch all the way through the rail. Mark your bit with masking tape if you have to. Overdrilling the hole in the handrail will allow you to push the new spindle up into the railing and then back down into the hole at the base.
You may need to cut down the new spindle to make it fit, but mind which side you trim down. If you cut too much off one side or the other, the shape of the replacement spindle may not line up exactly with the existing banister spindles. If the old spindle was glued in and the bond is still strong, you may have to cut the damaged spindle out flush and bore two new holes. If you think that the damaged spindle may be held in with a brad nail, dont use your most expensive Forstner bit to bore the new holes.
To find a matching banister spindle, start local. Try the lumberyard closest to your house. Theres a good chance the builder of your home purchased it there. If not, the folks working there may know where it came from. otherwise you could try an online source. Here are a few: cheapstairparts.com, stairpartsnow.com and stairwarehouse.com. If you cant find a new one, you may need to have one custom made by a local wood turner.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you startyoull save time and frustration.
You may also need spade bits
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.