Stop drafts and save energy by adjusting the bottom sweep on your exterior doors. It usually takes less than five minutes.
By the DIY experts of The Family Handyman Magazine
You might also like: TBD
Cut drafts by adjusting the screen door sweep
Adjust the sweep
Lower the sweep until it just blocks out light coming underneath. Then tighten the screws.
If your storm door drags on the threshold or lets in blowing snow, take a look at the lower edge. Most metal storm doors have an adjustable sweep that can slide up or down. Just loosen the screws on the inside of the door, raise or lower the sweep, and then tighten the screws. If the sweep is stuck, open the door, grab the underside with both hands and pull up as if you were trying to lift the door. That will break the sweep free. Making the adjustment is easiest on a sunny day: Position the sweep so that its rubber strip presses against the threshold just enough to block out sunlight. If the rubber gasket under the sweep is damaged and won’t provide a good seal, you may be able to order a new sweep. Look for the manufacturer’s nameplate (usually on the hinge side of the metal frame). Then search for the manufacturer’s contact information online. Some major manufacturers have online order forms.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.