Saturday Morning Workshop: Hairpin Leg Coffee Table
Though super-sleek with its mid-century modern design, this coffee table still has plenty of room for storage.
A few hours
IntroductionBuild this stylish hairpin leg coffee table in just a few hours. Follow along with the video tutorial and step-by-step photos below.
- Brad nail gun
- Circular saw
- dado stack
- Table saw
- 1-3/4-in. brad nails
- 1/4" nuts (12)
- 1/4" x 1-1/4" machine screws (12)
- 13/16" maple peel-and-stick edge banding (16')
- 16" hairpin legs (4)
- 4'x4' 3/4" maple veneer plywood
- Painter's tape
- Wood filler
- Wood glue
Don’t know where to get hairpin legs? These hairpin legs are incredibly well-machined and offer a sturdy solution.
Project step-by-step (9)
Cut parts to size
Rip the top and bottom to width on the table saw. Cut the center support from the end of either piece, using a circular saw and a straightedge.
Cut the miters
Set your table saw blade to 45 degrees and attach a long fence to your miter gauge. Miter one end. Mark 40 in. from the initial miter, line up the mark with the kerf in the miter gauge fence, and cut the other miter. Using the table saw fence, miter one edge of each side (B). Miter the other edge to make the sides’ finished dimension.
Apply edge banding
Cut edge banding strips for each part, leaving a little extra length. Remove the backing and apply the banding to the edges. To ensure good adhesion, rub the banding down with a wood block or a J-roller if you have one. With the edge banding face down on your bench, carefully trim the excess with a utility knife. Sand all the edges of the banding. Plus: Check out our 34 favorite handy hints for woodworking here.
Mark and cut the dadoes
Place the top onto the bottom, oriented how they’ll be when assembled. Mark a 3/4-in.-wide by 1/8-in.-deep dado on the edge of both parts. Make a small mark on one side of both pieces so you can re-create the orientation and ensure that the dadoes are aligned correctly. Cut the dadoes into the top and bottom (A).
Assemble the top
Glue the miters and clamp the sides to the top. Be sure to check for square. Reinforce the joints with brad nails if you like. Repeat with the center support (C).
Drill holes for attaching the legs
Measure 1 in. from each edge of the inside face of the bottom (A). Set the legs along the lines and mark the hole locations. Countersink and predrill 1/4-in. clearance holes.
Attach the bottom
Glue the side miters and the dado, then clamp. Reinforce the joints with brad nails through the side for added strength.
Fasten the legs
Drop the machine screws through the holes in the bottom (A), set the legs into place and secure them with 1/4-in. nuts.
Fill holes, sand and finish
Fill all the screw and nail holes with wood filler. Sand the table “through the grits,” ending with 320-grit. Apply your preferred finish. We used Watco Danish Oil in the natural color. Click here if you want to buy the same finish!
Every product is independently selected by our editors. If you buy something through our links, we may earn an affiliate commission.