Fit a gas water heater vent to a larger existing vent by using a reducer. Avoid changing out the entire gas vent.
By the DIY experts of The Family Handyman Magazine
You might also like: TBD
Connect a small gas vent to a larger one
New gas vent system
Install a reducer if you have to increase your vent size by 1-in.
Close-up of vent pipe reducer
A ‘reducer’ increases your vent diameter by 1-in.
If you find that your new gas water heater has a smaller vent than your existing gas vent, dont assume that you have to completely replace the venting system. If you cant find a unit that has the same size vent opening as your current water heater (or you just want a smaller unit), buy one with a vent opening thats just 1 in. smaller, then use a reducer to connect to the vent as shown. Use clamps or sheet metal screws and aluminum tape to connect the reducer. Install it on the horizontal part of the vent, at least 12 in. away from the elbow. Reducers are available at home centers for about $5.
Be sure to check building codes (this project requires a permit) and manufacturers specifications for any additional venting requirements.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you startyoull save time and frustration.
Drill bit set
Drill/driver - cordless
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.