Without gutters, rain and snow melt can flood steps, entryways and sidewalks. A rain diverter solves the problem without the expense of installing gutters by simply channeling water away.
By the DIY experts of The Family Handyman Magazine
You might also like: TBD
Install the diverter
Photo 1: Loosen the tabs
Lift the shingle tabs that are centered over the porch stoop by gently pushing the flat end of a pry bar under each tab. If the asphalt sealant holding the courses of shingles together won’t release, apply more force to the pry bar by punching the back of the bar using your palm or tapping the bar lightly with a hammer. Work in temperatures of about 40 to 70 degrees F.
Photo 2: Slide the diverter in
Apply a 1/4-in. thick bead of clear silicone caulk on the underside of the drip edge, lift the shingle tabs up slightly and slide the diverter under the tabs. Slide one end of the diverter tight to the bottom of the shingle tabs and leave a 1-in. exposure at the other end to create a drainage pitch.
Photo 3: Caulk
Apply a dab of silicone caulk to the vertical slots in the shingle tabs above the diverter to ensure that water doesn’t seep under the top edge of the metal.
If your house lacks gutters, rain that’s pouring off the roof will give you a good soaking when you come and go. In winter, melting snow creates a slip-and-fall hazard when it drips and freezes on porch stoops. Avoid those problems by taking 25 minutes and using the techniques shown in Photos 1 – 3 to install a rain diverter.
Purchase metal D-style drip edge (ordinarily used as roof edge flashing) and install it upside down as a diverter. Drip edge comes in 10-ft. lengths and is usually available in white, brown and unpainted aluminum. Cut it to length, equaling the width of your stoop. Also buy a 10-oz. tube of clear silicone caulk for use as an adhesive and sealant.
Work carefully to break the bond to release the shingle tabs (Photo 1). Work from a stable ladder centered on the doorway and release only those tabs along the third course of shingles up from the eave. To avoid breaking the tabs on older, brittle shingles, lift them only 2 to 3 in. On newer roofs where the shingles are more pliable, fasten the diverter in place using both silicone (Photo 2) and roofing nails. Space the nails every 2 ft. under the shingle tabs. Caulk the nailheads with silicone.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.